ECOTHERM EX SERIES

Oil / Gas Fired, Multi-Pass, Wet Back Type

Isotex Corporation has earned a formidable reputation for its constant focus on quality, superior design and high manufacturing standards for over two decades. It is this orientation that is reflected in its Ecotherm Thermic Fluid Heater range.

Ecotherm's unique Multi-pass wet back design, mono blocks burner proved reliability of components and high quality of construction material. All factors that have combined to make Ecotherm synonymous with high reliability, high efficiency, longer equipment and thermic fluid life and the lowest operational and maintenance costs.

Ecotherm is in use wherever indirect heating is required. User industries include, among others, textiles, edible oil, refineries, chemicals, paint, automobiles, metals, plywood, petroleum, food, paper, printing and where hot air, hot water and stream generation is by thermic fluid.

Multi-pass Wet Back coil type design provides Consistently high efficiency and output

Maximum heat absorption with lower rates of heat release Almost negligible refractory material which means, no refractory radiation and lowest residual heat, for improved heater coil and thermic fluid .

Horizontal/Vertical

Unit with front hinge door :-
Horizontal/Vertical heat exchanger & front hinge door, for ease of operation & maintenance.
Heater can easily be installed in a room with low ceiling height.
Faster maintenance, due to floor level operation, hence lesser down time.

Mono-Block Burner

Properly matched & selected from world leaders
Standard units are supplied with Riello ( Italy ) liquid/gas burners, the largest burner manufacturers in the world to provide
High combustion efficiency and reliability, lower power consumption, lower emission levels, ease of operation & maintenance, lower maintenance costs and lower noise levels.
High turn down ratios
Flexibility of unit operation with on-off/two stage/modulating burner.
Special burners also available for any other kind of liquid/gas fuels.